TEXTABOVELINE #
Overview #
The TEXTABOVELINE command in DWGSeeCAD creates text aligned with a selected line entity. You can place the text either above or below the line, set the text height, width factor, and enter your text content directly through command line prompts.

Command Prompt Workflow #
- Enter TEXTABOVELINE on the command line and press Enter.
- Prompt: [Text above line] Select line entity: Pick the target line for text alignment.
- Prompt: [Text above line] Place text above line (A)/Place text below line (B) <A>: Enter A for above the line (default), or B for below the line.
- Prompt: [Text above line] Specify text height:<5.00> Input the text height, or press Enter to use the default value 5.00.
- Prompt: [Text above line] Text width factor :<0.8> Enter the width factor, or press Enter to accept the default value 0.8.
- Prompt: [Text above line] Input text string: Type the text content and confirm.
- The text will be generated and aligned parallel to the selected line.
Options #
- A (Place text above line): Position text on the upper side of the selected line (default option).
- B (Place text below line): Position text on the lower side of the selected line.
- Text height: Defines the character height of the text, default value 5.00.
- Width factor: Controls the horizontal scaling of the text, default value 0.8.
- Text string: The content of the generated text object.
Usage Notes #
- This command works with straight line entities only; arcs, circles and polylines are not supported.
- The generated text automatically keeps parallel to the selected line.
- All parameters are configured sequentially in the command line, without pop-up dialogs.
- This is an exclusive extended command for DWGSeeCAD.
Application Scenarios #
Use TEXTABOVELINE for labeling leader lines, marking pipe lines, adding notes on section lines, and placing descriptive annotations parallel to straight geometry in mechanical, architectural and civil drawings.